ClimateRight CR2500ACH Bedienungshandbuch Seite 10

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 9
C
LIMATE
R
IGHT
MODE AND FAN OPERATION
6
-
3
C l i m a t e C o m f o r t A n y p l a c e I m a g i n a b l e
HEAT MODE
Turn on the unit by pressing the I/O button on the remote control.
Press the Mode Button until HEAT appears on the LCD display.
Press the +/- Temperature button until the desired room
temperature appears on the LCD. The temperature ranges from
61
o
F - 88
o
F (16
o
C - 31
o
C).
Select the fan speed by pressing the Fan Speed Button. It is
recommended to use a low fan setting.
The fan will continue to operate once the temperature reaches the
set temperature.
SLEEP
Turn on the unit by pressing the I/O button on the remote control.
Press SLEEP to enter into sleep mode
The fan motor of unit runs in low speed
When in cooling mode, within the first two hours, the temperature
will be increased 1°F per hour. Then temperature will stay at 2°F
higher than the original temperature for 8 hours. After 8 hours, the
temperature will return to original temperature.
When in heating mode, within the first two hours, the temperature
will be decreased 1°F per hour. Then temperature will stay at 2°F
lower than the original temperature for 8 hours. After 8 hours, the
temperature will return to the original temperature.
When in dehumidify mode, the temperature will not be changed.
6
-
4
T
IMER
F
UNCTION
C l i m a
t e C o m f o r t A n y p l a c e I m a g i n a b l e
TIMER FUNCTION
To set the timer to turn the unit On or Off: Press the T-On key,
the clock and the word ON will begin to flash. Press the Hour and
Min buttons until the desired on time has been reached. After a
few seconds of inactivity, the clock will stop flashing and the timer
will be set.
To set the timer to turn off, repeat the same steps with the T-Off
key.
Note: Timer can only be set in 10 minute increments.
POWER OUTAGE RECOVERY FEATURE
In the case of a power outage or interruption, the unit will
automatically re-start in the settings last used after the power is
restored. If the Delay 124hr feature was set, it will resume
countdown. If desired, a new time may be set.
Seitenansicht 9
1 2 ... 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare