LIMATE
IGHT
MODE AND FAN OPERATION
C l i m a t e C o m f o r t A n y p l a c e I m a g i n a b l e
6. MODE AND FAN OPERATION
AUTO MODE
Turn the unit on by pressing the I/O button on the remote control.
Press the Mode Button until the “AUTO” appears on the LCD
display.
Select the fan speed by using FAN button.
During the AUTO mode, the unit operates at heating mode when
the room temperature is below 68 degrees. It operates
dehumidifying mode when the room temperature is between 68
and 80 degrees. It operates at cooling mode when the room
temperature is above 80 degrees. The timer may be used with the
AUTO mode.
COOL MODE
Turn on the unit by pressing the I/O Button on the remote control.
Press Mode Button until “Cool” appears on the LCD display
Press the + / - Temperature button until the desired room
temperature appears on the LCD. The temperature ranges from
61
o
F-88
o
F (16
o
C-31
0
C).
Select the fan speed by pressing the Fan Button.
The fan will continue to operate once the temperature reaches the
set temperature.
NOTE: During hot days, the unit will cool off the room most
efficiently by setting the temperature at the lowest and the fan
speed at the highest. Reducing the length of the outlet duct and
insulating the outlet duct and keeping direct sunlight to a minimum
will also improve the cooling efficiency.
RY
EHUMIDIFYING
ODE
t e C o m f o r t A n y p l a c e I m a g i n a b l e
NOTE: If the air conditioner is off and is then turned on while set to
a Cool setting or if turned from a fan setting to a Cool setting, it may
take approximately 3 minutes for the compressor to start and
cooling to begin.
DRY (DEHUMIDIFYING) MODE
Turn on the unit by pressing the I/O button on the remote control.
Press the Mode Button until the “DRY” appears on the LCD display.
NOTE: The unit operates at low fan speed during dehumidifying.
The unit cools room slightly during the dehumidification.
Keep the windows and the doors closed to aid the effectiveness of
the unit in removing the moisture from the room.
NOTE: The unit will not perform dehumidification when the room
temperature is lower than 61 degree.
FAN MODE
Turn on the unit by pressing the I/O button on the remote control.
Press the Mode Button until “FAN” appears on the LCD display.
Select the fan speed by pressing the Fan Speed Button.
The HIGH, MED and LOW fan speeds can be chosen for the
following modes: AUTO, COOL, FAN and HEAT. Only the LOW fan
speed is available for DRY mode.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern